[VNUHCM S&T PROJECT EVALUATION] EXCELLENT RESULTS FOR STUDY OF P-TYPE CuCrO₂ DE-LAFOS-SITE MATERIALS

[VNUHCM S&T PROJECT EVALUATION] EXCELLENT RESULTS FOR STUDY OF P-TYPE CuCrO₂ DE-LAFOS-SITE MATERIALS

On 22 September, the VNUHCM-level science and technology project entitled “Evaluation of the Effects of Co-doping on the Electrical and Thermoelectric Properties of P-type Delafossite CuCrO₂ Semiconductor Materials”, led by Dr Hoàng Văn Dũng of the Advanced Materials Laboratory (AM-Lab), VNUHCM–University of Science (HCMUS), was successfully evaluated and received an excellent rating.

The project led by Dr Hoàng Văn Dũng and the research team aimed to improve the thermoelectric conversion efficiency of p-type delafossite CuCrO₂ semiconductor materials through a co-doping strategy. The research sought to advance the development of low-cost, environmentally friendly oxide thermoelectric materials with stability at medium to high temperatures.

The team completed all three objectives specified in the approved project proposal, achieving 100% completion. These objectives comprised the fabrication of doped CuCrO₂ materials; evaluation of electrical and thermoelectric properties; and analysis of the relationships between material structure, microstructure and properties. The materials were synthesised using a solid-state reaction method. Structural and microstructural characteristics were examined through X-ray diffraction, Raman spectroscopy and scanning electron microscopy, while electrical and thermoelectric properties were investigated using Hall effect and Seebeck measurements across a broad temperature range.

Dr Hoàng Văn Dũng presenting the research on behalf of the project team.

The study clarified how co-doping strategies influence charge transport and the thermoelectric performance of p-type CuCrO₂ materials. Appropriate dopant selection enabled simultaneous adjustment of electrical and thermal transport properties. The materials show potential for use in thermoelectric devices that recover waste heat from engines, industrial processes and natural heat sources, contributing to the development of sustainable energy conversion solutions.

The project met and exceeded the registered output targets, delivering one Q1-ranked Scopus-indexed international journal article in Materials Science & Engineering B, entitled “Defect-mediated carrier transport in Mg–Ti co-doped CuCrO₂ thin films via donor–acceptor compensation for thermoelectric applications”, Vol. 333 (2026), 119732; one conference presentation at the 2025 National Conference on Solid State Physics and Materials Science (SPMS 2025); five bulk samples of doped CuCrO₂, all exceeding the registered power factor targets; and one master’s student who successfully defended a dissertation.

The project contributes to research on functional oxide materials, thermoelectric materials and the control of structure–property relationships. The findings also provide a foundation for further research into materials for sustainable energy conversion.

The evaluation panel and Dr Hoàng Văn Dũng at the review session for the VNUHCM-level project.

Leave a Reply

Your email address will not be published.